Free Print Subscription Printer-friendly version Email to a Friend

Simple single-cell white-LED driver uses improvised transformer

( 01 May 2007 )
Jim Grant, Scientific Controls, Orlando, FL.

A white LED delivers a wide color spectrum and better visibility than do monochromatic LEDs. However, a white LED presents a higher forward-voltage drop than do its colorful counterparts and thus poses problems for operation from a single 1.5V cell. The self-oscillating step-up converter in Figure 1 features a minimal component count and an easily assembled transformer, T1.
During the time it takes to charge T1's primary inductance, resistor R1 and T1's added secondary winding provide sufficient base current to turn on Q2. Q2's collector current increases until its base current can no longer hold the transistor in saturation. When Q2 comes out of saturation, T1's magnetic flux and secondary-voltage polarity reverse. During T1's primary-discharge interval, the combination of T1's secondary voltage in series with Q1's base-emitter voltage applies reverse bias to Q2's base and turns off the transistor. When Q2 turns off, the voltage across T1's primary inductance adds to the battery voltage and applies a forward bias to the LED, D1. The current through R1 determines the power applied to the LED and applies forward bias to Q1's base-emitter junction to provide temperature-compensated bias voltage for Q2.
The breadboarded circuit's transformer, T1, comprises eight turns of AWG #30 insulated wire wound around the body of an unshielded 100-µH axial-lead inductor, producing approximately 400 mV p-p across the secondary winding. (Editor's note: Observe the winding's polarity dots. If the circuit fails to oscillate, reverse the connections to either the primary or the secondary winding.) The circuit operates over an input voltage range from just above Q1's base-emitter voltage drop of approximately 0.6V to the LED's forward-voltage drop of approximately 3V. The circuit's switching frequency exceeds 340 kHz at 1.5V input.

Caption

Figure 1 Two transistors and an easily assembled transformer drive a white LED from a single 1.5V battery.
Click here for Figures:

Figure 1

 
Free Print Subscription Printer-friendly version Email to a Friend
 
Article Rating 
Average Rate: No rating yet
 
Poor Quite Good Good Very Good Excellent
 
Related Content 
 
 
KNOWLEDGE CENTER
Panasonic Key Devices Guide 2008 :
 
Fairchild Semiconductor :
 
Texas Instruments: DaVinci™ Technology
 
Texas Instruments: Safe Bet Series
 
 
 
Highest Rated  
Feedback Loop  

ADS BY GOOGLE 
 
 
 
ADVERTISEMENT
Press Release 
 
TECHNOLOGY NEWS
 
RESOURCE CENTER

 
 
PRODUCT NEWS
 
FEATURED SPONSORS
 
 
DESIGN CENTERS
 
ADVERTISEMENT
     
Reference Designs 
   
     
 
 
 


 
 
RSS
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   

POLL
What type of environmental regulation do you think will be most beneficial for the tech industry?
Proper recycling and disposal
Push for power efficiency and energy conservation
Chemical/lead regulation
View results