Charger extends lead-acid-battery life

A circuit that properly charges sealed lead-acid batteries ensures long, trouble-free service. Figure 1 is one such circuit. It provides the correct temperature-compensated charge voltage for batteries having from one to as many as 12 cells, regardless of the number of cells being charged.


Click to enlarge


The circuit in Figure 1 furnishes an initial charging voltage of 2.5V per cell at 25°C to rapidly charge a battery. The charging current decreases as the battery charges, and when the current drops to 180mA, the charging circuit reduces the output voltage to 2.35V per cell, floating the battery in a fully charged state. This lower voltage prevents the battery from overcharging, which would shorten its life.

The LM301A compares the voltage drop across R1 with an 18mV reference set by R2. The comparator’s output controls the voltage regulator, forcing it to produce the lower float voltage when the battery-charging current passing through R1 goes below 180mA. The 150mV difference between the charge and float voltages is set by the ratio of R3 to R4. The LEDs show the state of the circuit.

Temperature compensation helps prevent overcharging, particularly when a battery undergoes wide temperature changes while being charged. The LM334 temperature sensor should be placed near or on the battery to decrease the charging voltage by 4mV/°C for each cell. Because batteries need more temperature compensation at lower temperatures, change R5 to 30Ω for a TC of −5mV/°C per cell if your application will see temperatures below −20°C.

When the circuit charges more than six cells, the additional voltage across the LM334 increases self-heating, so use a small heat sink and increase the resistance of R6. Likewise, use higher resistances in series with the LEDs to avoid overloading the LM301A.

The charger’s input voltage must be filtered dc that is at least 3V higher than the maximum required output voltage, which is approximately 2.5V per cell. Choose a regulator for the maximum current needed such as LM317 for 1.5A, LM350 for 3A, or LM338 for 5A. At 25°C and with no output load, adjust R7 for a VOUT of 7.05V, and adjust R8 for a VOUTof 14.1V.


Originally published in the February 7, 1985 issue of EDN